Offer Details

Enquiry No. : 4111980 New York (USA)

Description :Does your company handle the specification
listed below and if so, do you have a U.S. (Northeast)
region agent or representative

Long Sleeves Dress Shirt.
Material:
All fabric used shall be permanent press, machine
washable, and shrinkage resistant.

Description:
The shirt shall have a placket front, collar stand,
one left breast pocket, long sleeves with button cuffs,
and a 7 button closure including the collar button.

Content:
65% polyester/35% cotton
Weight:
3 oz./yd.2 minimum
Construction:
Left Front:
Shall have a placket a minimum of 1-1/4? wide,
and shall be the entire length from collar to the bottom
of the shirt. It shall have six well made buttonholes
properly spaced. There shall be a single row of stitching
on each edge.

Right Front:
Shall have a turn back of 1? minimum with one row of
stitching.
The button stand shall have six 4-hole buttons properly
placed to match the buttonholes on the left front.

Collar Stand:
Shall be minimum of 1-1/2? high at center back, shall be
fabricated of 2 ply self fabric, and shall have a woven
innerlining. It shall be attached to the shirt body with
two rows of stitching. The stand shall have one button
and one buttonhole.

Collar:
The collar shall measure a minimum of 1-3/4? high at
center back, shall have collar points of 2-5/8? minimum,
medium plastic collar stays secured in place and a Dacron
woven interlining. The collar shall have a single
row of top stitching and shall be attached to the collar
stand with one row of stitching.

Pocket:
The shirt shall have a breast pocket on the left side.
It shall be 4-1/4? wide x 4-1/2? high at each side x 5?
high at center point. It shall have a turn back of 1-1/4?
and be top stitched. The top corners shall have a
triangle top stitch, and the sides and bottom shall have a
single row of stitching. All dimensions are minimum with
a tolerance of +1/4? only.

Sleeves:
The sleeve shall have a vent with an opening
of 4-3/4? +1/4? from the top of the cuff. The vent shall
be placket style 1? wide, and top stitched.

Cuffs:
The cuffs shall be 2-ply self-fabric, a minimum of 2-1/2?
wide, shall have rounded corners, woven dacron
innerlining, and shall have a double row of stitching at the
top and a single row on the other three edges.
The cuff shall have one buttonhole on one cuff end, and
two (2) horizontally located buttons spaced 1? apart on
the other cuff end.

Yoke:
The yoke shall be 2-ply self-fabric, shall measure 2-1/4?
high at centerback x 2-1/2? at shoulder seams, minimums.

Stitching:
All component parts shall be assembled using 10-12
stitches/inch minimum.
All inside seams shall be finished with a marrow
stitch/safety stitch.
Machine tension shall be such that no puckering of
material shall occur.

Short Sleeve Dress Shirt.....
Description:
The shirt shall be the same as Item No. 1, except the
shirt shall have short sleeves with a 3/4? hem and
top stitched. The sleeves shall be a minimum of 9?
long measured from the shoulder seam.
Thank you.