Enquiry No. : 6120280 Athens (Greece)
Description :We are looking to buy Leather Working Gloves/ Welder Gloves
Working leather gloves should be:
EN 388 (mechanical risks) certified with minimum protection
levels 3. 1. 4. 4 . Water permeability should be at least
2 mg / cm2. H per. EN 420 par. 6. 4. EN420 (general
requirements) dexterity = 5 with pictograms & CE mark.
Gloves should be made of cattle leather 1, 2-1, 4 mm & 100%
cotton dock fabric and have woven cotton lining (cuff leather
should be split of 1, 2-1, 4 mm) . At the wrist area should
exist elastic strip from inside part to fit better with the
hand
Certificates accompanied by test report issued by notified
body should be submitted for proving compliance with the above
Will not be replied non-certified gloves