Offer Details

Enquiry No. : 6083070 Istanbul (Turkey)

Description :We need copper foil to make lamination with polyester.
The copper foil thickness which we use to produce CU PET is
15,18 and 20 micron. The both copper foil surface must be
bright. Do you have any copper foil which we need? If you have
such products and able to give some reasonable and competitive
prices, we will be very glad to form a new business
collaboration. We will use it in lamination applications
for polyester film and aluminum foil. Our monthly consumption
is 4-6 tones at least Technical details of the copper foils
which we demand are as below:

Micron Width Quantity ( Tone )

15micron 650 mm 2 ton

18micron 650 mm 2 ton

Our consumption demand is an above at the moment, We plan to
buy 4 tones of copper foil each 30 days but as I said, if we
have a good price for copper foil, our consumption rate will
increase significantly by the time.

The technical details of the copper foil which we use are
as below:

Material: ETP- Copper Foil
Hardness: Soft
Dimensions: 0.015 x 300 mm

Production Data:
Thickness
Nominal:0.015 Actual:0,014 mm
Width Nominal 300mmActual 300mm
Yield Point Rp 0,2 N/mm
Tensile strength Rm N/mm Actual betw.144,2 197,9

Elongation L100 mm Actual betw.9,2 12,7
Vickers hardness 0.3/15 HV
EL. Resistance ( 250 mm )

Material: ETP Copper Foil
Hardness: Soft
Dimensions: 0.018 x 300 mm

Production Data
Thickness
Nominal 0.018 Actual 0.018mm
Width
Nominal 300 Actual 300 mm
Yield Point Rp 0,2 N/mm
Tensile strength Rm N/mm
Actual betw.130,1 133,2

Elongation 100 mm
Actual betw.9,9 10,2
Vickers hardness 0.3/15 HV
EL. Resistance ( 250 mm )
Surface roughness

Our supplier has provided a typical chemical analysis for the
copper as follows: ( All values are given in ppm )
Pb<2 ; Bi<1 ; AS = 1 ; Sb = 1 ; Sn<1 ; Zn<3 ;
Fe = 5 ; Ni = 5 ; Ag = 8 ; Se<1; Te<1 ; S = 5

The copper content (including silver and oxygen ) is min.99.9.

The productivity is min.100% IACS, at 20C in soft annealed
condition.

Note: We laminate the copper foil with polyester.
Polyester is first takes the glue from the steel cylinder and
then pass heat through a channel. In that channel polyester is
heated under 70 C and by this way, the ethil inside the glue
goes away and then the polyester is laminated to copper foil.
Namely we can say that, we do not make any heat treatment
for copper foil. After the lamination process, laminated
copper is cut in 14,18 and 27 mm width, according to the
demand of customers. Our polyester laminated copper foil is
especially used for coaxial cable.